A+ GPB 300W ATX Power Supply

Product Description A+ GPB 300W ATX Power Supply Product Features High efficiency Low Ripple & Noise Output over voltage protection Short circuit protection on all output Resettabel power shut down Approved by UL1950, TUV EN60950, IEC 950 Internal 12 VDE fan provided Complies with FCC part 15 subpart J class B at 115VAC operation & CISPR 22 Class B at 230 VAC operation 100% burn-in under high ambient temperature (50C) Vacuum-impregnated transformer MTBF: 50K HOURS at 25C 100% Hi-pot tested & ATE tested Built-in EMI filter Product Specifications Atx / P4 12v read 300w 5 12V +1 serial connector UL CE&CB Over voltage protection: +5V output: 6.5V +3.3V output Overload protection: 150% max. 4.6V +12V output: 15.5V AC INPUT: 115/230 Vac ~ 10/5A 60/50Hz DC OUTPUT: $Voltage: +3.3V, Output: 20A $Voltage: +5V, Output: 25A $Voltage: -5V, Output: 0.5A $Voltage: +12V, Output: 12A $Voltage: -12V, Output: 0.5A $Voltage: +5V-SB, Output: 2.0A Remote ON/OFF Control: The power supply shall accept a logic collector level which will disable/enable all putput voltage (excluding +5V standby). Temperature Range: operating 0cJ~50cJ, storage -20cJ ~ +80cJ Temperature coefficient: 0.01%/cJ Transient response: output voltage recovers in less than 1 ms max. following a 25% load change Hold-up time: 16ms minimum at full load & nominal input voltage Dielectric withstand: input/output 1800VAC for 1 second, input to frame ground 1800VAC for 1 second Humidity: 5~95% RH Efficiency: 65% min. 70% typical, at full load Power good signal: turn-on delay 100 ms to 500ms Overload protection: 150% max. Inrush current: 60A cold, 65A ware at 132 VAC